I'm 48 minutes (my local time) late for my thing-a-day! Finally, here it is. It's a flat (boring?) oval (can be perfectly circular too) open (of course, you can close it) asimetrical (thinner at the open side) bracelet (or ring if you make it smaller). This design is intended to be an envelope to be boolean used (intersection) with other textured designs, we'll see...

This one is 6 cm x 5 cm (inside dimensions) and a little bit more than 2.9 cm tall.
Thickness varies because is asimetrical. It should be a maximum of 0.36 cm and a minimum of 0.21 cm.
The opening has been set to 2 cm, you can change all this, and more, in the OpenSCAD script parameters.
Use it to carve logos, textures, just write something on it or you can also print it as it is.
I've been mercy less with booleans and I go quite crazy with the resolution... it may take time to compile (decreasing the resolution by increasing "res" parameter speeds up the whole thing)

Flat Open Bracelet

Filatrix Filatrix

This design is intended to be an envelope to be boolean used (intersection) with other textured designs, we'll see...

FEATURES

This one is 6 cm x 5 cm (inside dimensions) and a little bit more than 2.9 cm tall.
Thickness varies because is asimetrical. It should be a maximum of 0.36 cm and a minimum of 0.21 cm.
The opening has been set to 2 cm, you can change all this, and more, in the OpenSCAD script parameters.
Use it to carve logos, textures, just write something on it or you can also print it as it is.
I've been mercy less with booleans and I go quite crazy with the resolution... it may take time to compile (decreasing the resolution by increasing "res" parameter speeds up the whole thing)

PARTS1

COMPATIBLE PRINTERS338authorised to print at least one part

FOOTPRINT

Width50.0 mm

Depth30.0 mm

Height60.0 mm

HOW IT PRINTS

flatOpenBraceletTPU